« previous next »
Pages: 1 [2]   Go Down

Author Topic: Tractor show  (Read 3351 times)

0 Members and 39 Guests are viewing this topic.

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Tractor show
« Reply #10 on: April 11, 2018, 05:24:52 am »
I haven't seen a small block Ford in an 8n either .My comment was about old Jeeps with V8 engines .
All this sounds good but often it doesn't work out so well .I don't care what it is you increase the power by 3 or 4 times something is going to fail .
I once saw what was left of an old Cletrac crawler somebody stuck a Ford 289 in to replace the 6 cylinder Continental flat head engine .They used the Ford three speed tranny locked in second gear .It tore the finals out of the crawler .What was left was 5 tons of scrap cast iron .
Logged

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Tractor show
« Reply #11 on: April 11, 2018, 05:44:43 am »
Rambling on what will surprise folks is how much power an old Farmall F-20 will take .They would take Chevy 454 and Ford 429-460 engines,souped to the gills and pull them in the super modified tractor pulls .That rear end was designed for about 20 HP and might have over 500 on it with big fat combine rice tires spinning at about 70 MPH .That amazed me .




Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
47 Replies
8015 Views 		Last post October 09, 2017, 04:10:59 pm
by Al Smith
0 Replies
1212 Views 		Last post October 22, 2011, 01:25:54 pm
by Cut4fun .
9 Replies
2956 Views 		Last post December 09, 2011, 06:36:47 pm
by Al Smith
1 Replies
1371 Views 		Last post December 22, 2011, 04:27:24 pm
by Cut4fun
0 Replies
640 Views 		Last post August 03, 2012, 02:32:02 pm
by Cut4fun .
24 Replies
5949 Views 		Last post January 09, 2018, 06:08:23 am
by Al Smith
3 Replies
1300 Views 		Last post September 28, 2013, 06:17:45 pm
by dutchsawdoctor
11 Replies
1891 Views 		Last post May 30, 2015, 10:05:06 pm
by 660magnum
1 Replies
1700 Views 		Last post July 28, 2018, 07:54:41 am
by Al Smith
2 Replies
1342 Views 		Last post October 10, 2018, 12:03:20 am
by 3000 FPS