« previous next »
Pages: 1 [2]   Go Down

Author Topic: Porting Intake  (Read 3600 times)

0 Members and 63 Guests are viewing this topic.

Offline

  • 4 cube
  • **
  • Posts: 51
  • Karma: 14

    • Total Badges: 21
    Badges: (View All)
    Level 5 50 Posts Fifth year Anniversary Linux User Level 4 Fourth year Anniversary
Re: Porting Intake
« Reply #10 on: November 30, 2015, 02:14:42 pm »
The only reason to make the bottom of the intake port close/open progressively is to take it easy on the piston skirt . Make the intake 70% wide and the bottom of the port totally flat , run it 5 minutes and look at the piston skirts , it sure won't look good !
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
6 Replies
3501 Views 		Last post June 01, 2016, 09:03:45 pm
by RobbinW
10 Replies
2970 Views 		Last post August 27, 2012, 01:13:55 pm
by CASE5854x4
4 Replies
842 Views 		Last post November 10, 2013, 08:08:03 pm
by eatonpaving
4 Replies
957 Views 		Last post November 19, 2013, 08:08:11 pm
by jacob j.
3 Replies
1173 Views 		Last post January 18, 2014, 12:51:59 pm
by jacob j.
2 Replies
715 Views 		Last post October 05, 2014, 03:44:30 pm
by farmboy
7 Replies
2644 Views 		Last post December 18, 2014, 05:18:24 pm
by Nathaniel Vansickle
1 Replies
581 Views 		Last post January 27, 2016, 11:34:07 am
by Skippysphins
6 Replies
2176 Views 		Last post January 23, 2020, 08:52:42 pm
by ENTS
0 Replies
563 Views 		Last post April 12, 2024, 07:18:31 am
by Cut4fun