« previous next »
Pages: [1]   Go Down

Author Topic: Stihl 044/440 pto crank seal.  (Read 1480 times)

0 Members and 50 Guests are viewing this topic.

Offline

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2114
  • Karma: 172
  • Location: VA

    • Total Badges: 36
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 6
Stihl 044/440 pto crank seal.
« on: August 27, 2016, 09:50:29 pm »
Anyone have a good way of getting the bearing spacer/ sleeve down in the oil seal with out blowing the spring of the seal? Sometimes I have good luck and it goes right together and all is well. Sometimes not so much.
Logged

Share on Bluesky Share on Facebook

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Stihl 044/440 pto crank seal.
« Reply #1 on: August 29, 2016, 05:07:18 am »
Make a spreader from a thin plastic tube or thin shim stock .Use some oil to slip it over the shaft .
Logged
Like Like x 1 View List
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
6 Replies
3971 Views 		Last post March 09, 2012, 06:30:02 pm
by Cut4fun .
29 Replies
6878 Views 		Last post July 20, 2015, 08:04:45 am
by Al Smith
11 Replies
5660 Views 		Last post October 29, 2013, 08:57:24 am
by davbell22602
3 Replies
1498 Views 		Last post February 13, 2014, 11:21:23 pm
by Eccentric
15 Replies
4218 Views 		Last post April 30, 2015, 09:36:19 am
by aclarke
9 Replies
3686 Views 		Last post December 30, 2018, 09:08:12 am
by Al Smith
1 Replies
1166 Views 		Last post February 13, 2018, 06:51:07 am
by Cut4fun .
1 Replies
1735 Views 		Last post September 25, 2024, 07:50:48 am
by Cut4fun .
0 Replies
382 Views 		Last post April 16, 2025, 04:26:24 pm
by Cut4fun
1 Replies
235 Views 		Last post February 22, 2026, 09:57:59 am
by Cut4fun .