« previous next »
Pages: 1 [2] 3   Go Down

Author Topic: timing  (Read 4323 times)

0 Members and 23 Guests are viewing this topic.

Offline

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2114
  • Karma: 172
  • Location: VA

    • Total Badges: 36
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 6
Re: timing
« Reply #10 on: January 17, 2013, 06:51:57 pm »
So if there is 64, 1/16 in four inches and you wanted to advance the timing to 30 degrees.  You would set it at 30/16. Correct? and that is from TDC at 0. I am trying to understand what al said.
Logged
Pages: 1 [2] 3   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
8 Replies
3217 Views 		Last post May 12, 2012, 09:30:03 pm
by Al Smith
5 Replies
4459 Views 		Last post January 22, 2014, 02:46:36 pm
by danders
17 Replies
5164 Views 		Last post February 14, 2014, 10:46:23 am
by 660magnum
6 Replies
2308 Views 		Last post November 02, 2015, 07:43:33 pm
by Al Smith
2 Replies
4358 Views 		Last post March 20, 2016, 01:15:19 pm
by 660magnum
5 Replies
1972 Views 		Last post July 20, 2016, 07:33:47 pm
by 1manband
21 Replies
11560 Views 		Last post October 17, 2016, 08:19:31 pm
by dannyupsolate
0 Replies
1057 Views 		Last post October 12, 2016, 02:12:43 pm
by Cut4fun .
Saw timing

Started by rls8836 « 1 2 » Poulan

12 Replies
3093 Views 		Last post April 06, 2017, 07:46:22 pm
by 660magnum
4 Replies
2092 Views 		Last post November 02, 2017, 06:30:13 am
by Al Smith