« previous next »
Pages: [1]   Go Down

Author Topic: Metal Lathe FS  (Read 1982 times)

0 Members and 50 Guests are viewing this topic.

Offline

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 24888
  • Karma: 665
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

    • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Metal Lathe FS
« on: May 09, 2012, 03:28:17 pm »
I seen a 6" 3 jaw metal lathe that appeared to be on a bench top. Appeared to be a blue in color and didnt see any name listed or model in pic. Guy was asking $500.
Logged

Share on Bluesky Share on Facebook

Offline

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Metal Lathe FS
« Reply #1 on: May 09, 2012, 08:32:08 pm »
Those little table top Atlas's etc are too small to do much but to turn bushings or something tiny .

The "Bushweasel " had one that I sent him a bunch tooling for .It would barely turn a saw cylinder .
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
2973 Views 		Last post August 02, 2011, 03:27:25 pm
by Al Smith
1 Replies
1288 Views 		Last post August 24, 2014, 08:11:47 pm
by tlandrum
18 Replies
3158 Views 		Last post December 17, 2014, 10:47:07 am
by srcarr52
14 Replies
2905 Views 		Last post March 29, 2015, 01:51:20 pm
by Cut4fun .
6 Replies
2788 Views 		Last post November 30, 2015, 04:15:44 pm
by 1manband
13 Replies
4032 Views 		Last post December 11, 2015, 10:19:46 pm
by Al Smith
51 Replies
9943 Views 		Last post March 12, 2019, 10:18:52 am
by Cut4fun .
5 Replies
3833 Views 		Last post April 08, 2023, 08:46:11 am
by Cut4fun .
1 Replies
1818 Views 		Last post September 18, 2017, 08:38:44 pm
by 3000 FPS
5 Replies
2392 Views 		Last post April 08, 2018, 10:13:28 am
by jcsmith