« previous next »
Pages: 1 [2]   Go Down

Author Topic: Echo cylinder  (Read 1493 times)

0 Members and 25 Guests are viewing this topic.

Offline

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37

    • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Echo cylinder
« Reply #10 on: November 27, 2014, 07:24:28 am »
I like my 520's especially with 18 inch bars and 325 lpx20 chain.  They are light and nimble. 

When you seal it up, make sure you get into the corners of the bearing pockets where they fit into the casting.  Use a little extra goo top and bottom (loctite 515).   
Logged

Offline

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama

    • Total Badges: 19
    Badges: (View All)
    Fifth year Anniversary Fourth year Anniversary Third year Anniversary Level 4 100 Posts Avatar
Re: Echo cylinder
« Reply #11 on: December 04, 2014, 01:14:03 pm »
I received the parts a few days ago---Fast---- and they looked really good. I installed a new set of rings and they gapped at seven thousands, after lightly cleaning cylinder with scotch-brite. Saw runs again---thanks to Cut4fun!
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
13 Replies
5898 Views 		Last post December 07, 2011, 05:32:23 pm
by brokenbudget
1 Replies
1358 Views 		Last post September 05, 2012, 05:23:21 pm
by Al Smith
044 Cylinder

Started by farmboy « 1 2 3 4 » Stihl

38 Replies
4339 Views 		Last post June 02, 2013, 10:02:21 pm
by HolmenTree
54 Replies
17581 Views 		Last post January 03, 2014, 02:14:59 pm
by Adirondackstihl
14 Replies
3131 Views 		Last post February 25, 2014, 12:38:59 pm
by jacob j.
7 Replies
2215 Views 		Last post January 18, 2016, 12:54:40 pm
by randy_das
4 Replies
1373 Views 		Last post November 06, 2016, 10:35:55 am
by SawTroll
7 Replies
3634 Views 		Last post August 25, 2017, 06:40:44 am
by jmester
0 Replies
1135 Views 		Last post December 23, 2022, 07:59:46 am
by Cut4fun .
2 Replies
2355 Views 		Last post July 26, 2024, 08:54:01 am
by Cut4fun .