« previous next »
Pages: [1]   Go Down

Author Topic: Compression and exhaust port  (Read 1347 times)

0 Members and 44 Guests are viewing this topic.

Offline

  • 5 cube
  • ***
  • Posts: 141
  • Karma: 17

    • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Compression and exhaust port
« on: September 25, 2014, 09:14:09 pm »
Double checked the squish and it comes in at .035, Which I prefer as I'm not a big fan of those super tight squishes. As for the  anti ridge,I just worked the corners when widening and didn't touch the middle. Opened the port from 23.5 to 27mm mostly on side as the other side was already  a straight shot. Hope to fire it up this week-end. Thanks for the mix ratio tip.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
9 Replies
3362 Views 		Last post November 16, 2014, 01:13:35 pm
by Cut4fun .
56 Replies
6346 Views 		Last post December 27, 2013, 02:20:57 pm
by 1manband
Compression

Started by ed McCulloch

8 Replies
5234 Views 		Last post February 07, 2012, 03:07:10 pm
by Al Smith
2 Replies
1346 Views 		Last post March 19, 2013, 04:14:39 am
by Al Smith
20 Replies
3663 Views 		Last post November 09, 2013, 10:09:18 am
by Moparmyway
36 Replies
5555 Views 		Last post November 28, 2018, 04:34:07 am
by Al Smith
1 Replies
1928 Views 		Last post January 25, 2016, 11:21:00 am
by srcarr52
0 Replies
1936 Views 		Last post April 07, 2016, 01:41:04 pm
by Cut4fun .
4 Replies
3459 Views 		Last post April 18, 2018, 01:10:06 am
by 660magnum
1 Replies
2016 Views 		Last post January 16, 2021, 07:16:55 am
by Cut4fun .